Cracked Tooth Treated with Medit i500 and emax Milled With Z4 by VHF
The following case demonstrates how a symptomatic cracked tooth was treated with an emax restoration that was fabricated / seated during the same appointment as it was prepared. The patient...
Sleep Apnea Device Fabrication from Conventional Impressions to Digitization with the Medit i500
There are many ways to capture the upper and lower jaw digitally and mount them correctly in a protrusive and open bite for obstructive sleep apnea devices. In this videos...
How Would You Like No Adjustment Appointments to With Your Oral Apnea Appliance Deliveries?
One of the greatest challenges in oral appliances for obstructive sleep apnea therapy is to capture the bite in the protrusive and open position in such a fashion so that...
Print Quality is Very Important for Fabrication of Oral Appliances or Restorations
A very important principle to keep in mind with intra-oral scanners is how that data is printed. There are too many reasons to list what can constitute a mis-print. One...
Four Unit Anterior eMax Bridge with Medit i500, exocad, and Z4 Milling Machine
The following case is a 4 unit splinted bridge where the upper central incisors where root canal treated. The laterals remained vital after trauma to the upper maxilla fracture a...
